321 Li Full
Hybrid Long Irons - Please
call or email for pricing.
Features and
Benefits:
The Model
321Li hybrid long iron replacements are finally the ultimate in
true, full hybrid long iron design due to the accompanying design
of the matching GI-335 graphite iron shaft or the Series 5 Steel
shaft.
Tom Wishon's
research has shown that the shaft can be a major contributor to
the launch angle of any club, but only if the shaft is designed
to bend/deflect an amount much greater than is typical with a
conventional iron shaft. Typical iron shafts only bend/deflect
1-2" in the swing. But wood shafts bend/deflect 4-6"
in the swing. The challenge of the GI335 and Series 5 Steel shaft
was to design them so that they had the same butt stiffness as
a conventional iron shaft, but with a tip design that would not
cause the shafts to feel too "whippy" when used with
the heavier headweight of an iron.
321Li full
hybrid long iron heads are designed in 1, 2, 3 and 4 irons and
will match with any set of irons to offer the golfer a much higher
trajectory from the bending of the unique iron tip design of the
GI-335 and Series 5 Steel shafts.
321Li full
hybrid long iron heads are designed with a hosel to face position
that is much more like a true iron for the proper appearance and
set up at address.
A cross-section
view of the wall thickness of the 321Li head design shows another
reason for the easy playability of this model - the rear wall
of each 321Li is extremely thick to pull the Center of Gravity
farther back from the shaft to further assist with increasing
the launch angle of the shot.
321Li heads
are designed with 0" roll just like an iron, but with a slight
20" horizontal bulge radius to match with the location of
the Center of Gravity farther back from the face than a typical
ironhead.
321Li full
hybrid long iron heads are finished in an attractive dark grey
metallic with bright satin highlights on the sole and toe/heel.
