Swing
Easy Golf's Fitting Equipment
Fitting
and Practice Studio.
This
is a fully enclosed state of the art Swing Analysis Studio. We use
several different pieces of equipment to analyze your swing and
your ball flight characteristics. This
system can also be used to play practice holes, a complete round
of golf or calculate your yardages for each club in your bag and
allows you to print out a bag tag of these yardages.
 |
Zelocity
Pure Flight
Ball Flight Monitor. This monitor is a Doppler
Radar Unit that measures Club Head Speed, Ball
Speed and Smash Factor.
Smash Factor is also known as Power Transfer Ratio. Optimum
is about 1.5, otherwise stated as ball
speed is 1.5 times the club head speed. A club head
speed of 100 mph striking a golf ball mostly in the middle of
the club head that is square at impact will produce a ball speed
of 150 mph. These measurements give us a good starting
point for shaft bend profile determination.
|
Lie
Mark Lie Angle Board.
This tells us how flat or upright your swing is and gives us the
information we need to bend the heads if necessary to match you
swing plane so that the ball starts out
going straight.
| P3ProSwing
Swing Analyzer. This analyzer tells us a
great deal about your swing mechanics, including club head speed,
ball speed, swing
path, face angle, angle of attack
and impact position on the face.
Obviously we can make many determinations from this much information.
Again, this helps us with shaft selection and also club head
design choice so that we can find the shaft and club head combination
that produces the most consistent ball flight for your swing. |
|
Putter
Fitting
 |
Mitchell
Golf Equipment Putter Fitting Club. This uniquely
designed putter lets us determine loft
and lie angles for your setup.
In other words we don't change your setup, we just match your
putter to your setup. The putter fitting club tells
us your proper length, lie angle
and how much loft you are adding
or subtracting from the face with your setup.
Mitchell
Golf Equipment Putter Bending Machine
with Putter Fitting Gauge. This machine and gauge combination
allows us to first measure your setup position with your putter. The
gauge actually attaches to your existing putter and tells
us lie and loft
information.Then we mount your putter in the putter bending
machine to find out what the loft
and lie angles actually are. |
|
From there we can bend your putter to match your setup so that
the ball starts out on line and with three to four degrees of
loft so that the ball begins to roll
as quickly as possible reducing skidding.
|
 |
|
